Article ID : 00017588 / Last Modified : 05/25/2015

Unable to turn the projector back on via RS232 Command after it has been idle for a while.

Applicable Products and Categories of This Article

IMPORTANT: This article applies only to specific products and/or operating systems. Check the Applicable Products and Categories section of this article before starting these steps.

Follow these steps if you are unable to turn the projector on using the RS232 Command after it has been idle or in standby mode for while.

NOTE: For model-specific information regarding any of the information or steps in this solution, refer to the supplied manual. Manuals are posted on your model support page.

  1. Set the projector Standby Mode to Standard.
  2. Send the power ON/OFF command twice.

NOTE: When the Standby Mode is set to Low, the Auto Power ON function is disabled.