Article ID : 00021410 / Last Modified : 07/09/2015

The overheat indicator blinks on the LCD panel.

Applicable Products and Categories of This Article

IMPORTANT: This article applies only to specific products and/or operating systems. Check the Applicable Products and Categories section of this article before starting these steps.

If the flash heats up after continuous shooting or when using it in hot environments, it may stop working. To help prevent overheating, do not exceed more than twenty continuous flash emissions. Set the POWER switch to OFF for approximately 10 minutes to allow the flash time to cool down.

NOTE: For the HVL-F60M flash, when you attach the bounce adapter (supplied) the camera automatically sets the zoom position of the flash to the widest value regardless of the focal length of the lens used. This causes the flash to continuously light up a wide area and increases the amount of flash light, causing the camera to overheat easily. When you have attached the bounce adapter, rest the camera for about a minute between shooting to prevent overheating. Use the bounce adapter only when you use bounce flash photography. Except with bounce flash photography, the adapter does not give softer lightning effect.