Article ID : 00023644 / Last Modified : 09/20/2016

Enable USB support in the BIOS.

Applicable Products and Categories of This Article

IMPORTANT: This article applies only to specific products and/or operating systems. Check the Applicable Products and Categories section of this article before starting these steps.

Follow this procedure to enable USB support in the BIOS.

  1. Restart the computer.
  2. Press and hold the F3 key at the opening SONY screen.
  3. Press the F1 key to enter Setup.
  4. Press the RIGHT ARROW key to highlight Advanced.
  5. Press the UP ARROW key or DOWN ARROW key to highlight Peripheral Configuration.
  6. Press the ENTER key.
  7. Press the DOWN ARROW key to highlight USB Interface.
  8. Press the ENTER key.
  9. Press the (+) key or (-) key to change the setting to Enabled.
  10. Press the ESC key two times.
  11. Press the ENTER key twice to Exit Saving Changes.