Article ID : 00024894 / Last Modified : 08/15/2015

The audio is too low or there is no sound at all from the speakers of a DVD/Receiver combo.

Applicable Products and Categories of This Article

Follow the steps below to troubleshoot this issue.

IMPORTANT: Consult the instruction manual if further information is required to perform any of the steps below. Manuals are posted on your model support page.

  1. Ensure the Mute function has not been activated.
  2. Try turning up the volume level.
  3. Try setting the receiver to a different Surround Sound mode.

    IMPORTANT: Make sure the disc is encoded with Surround Sound audio. If not, the audio will be very difficult to hear using a Surround Sound setting. Set the Surround Sound setting to OFF when viewing discs that are not encoded with a Surround Sound signal.

  4. Check the speakers to make sure they are properly connected to the receiver.
  5. Perform a test tone function to verify if the speakers are working correctly.
  6. Ensure all external audio sources are securely connected to the appropriate inputs on the receiver.

    NOTE: If the audio is being sent from a television to the receiver, then it may be necessary to disable the internal speakers of the TV or set the audio output of the TV to FIXED or VARIABLE . If the audio output of the TV is set to VARIABLE, then you will need to increase the volume level of TV.

  7. Ensure the correct audio input is selected on the receiver.
  8. Ensure no headphones are connected.
  9. Ensure the Demonstration Mode is not active.
  10. Change the ATTENUATE setting.

    NOTE: The procedure to change the Attenuate feature varies by model. Check the instruction manual provided with the system for specific information.

  11. Reset the receiver back to factory specifications.

NOTE: The troubleshooting steps listed above should resolve your issue. If you have completed all of the steps and the issue is not resolved, service may be required. Go to Product Repair.