Article ID : 00026202 / Last Modified : 08/16/2015

How to configure the RoomLink™ Media receiver for use with the Wireless Local Area Network (LAN) Ethernet converter.

Applicable Products and Categories of This Article

  1. On the Remote Commander® remote control [FIG. 1] , press the MAIN MENU button.
  2. Press the UP ARROW button or DOWN ARROW button to select SETTINGS .
  3. NOTE: Screen captures [FIG. 2] are available for reference.

  4. Press the SELECT button.
  5. On the SETTINGS menu, use the UP ARROW or DOWN ARROW to select SYSTEM SETTINGS .
  6. Press the SELECT button.
  7. On the SYSTEM SETTINGS menu, use the UP ARROW or DOWN ARROW to select IP ADDRESS .
  8. Press the SELECT button.
  9. On the IP ADDRESS menu, use the UP ARROW or DOWN ARROW to select Obtain an IP address automatically (not using a router) .
  10. Press the SELECT button.
  11. Use the UP ARROW or DOWN ARROW to select the OK button.
  12. Press the SELECT button.
  13. Follow the on-screen instructions to save the settings and to power off the receiver.
  14. Turn on the media receiver.
  15. NOTE: Wait 20 seconds for the media receiver to complete the update.