Article ID : 00030220 / Last Modified : 08/16/2015

When the Blu-ray Disc® (BD) player is connected to a stereo system using the 5.1CH OUTPUT jacks there is no sound from rear surround sound speakers.

Applicable Products and Categories of This Article

If this occurs, then the Blu-ray Disc® (BD) player may be currently set to output 2 Channel instead of 5.1 Channel audio and the left and right speaker setting may not be set properly. Follow the steps below to set the BD player to properly output rear sound from the 5.1CH OUTPUT jacks.

  1. If there is a disc currently playing, press the STOP button on the remote control or front of the player.
  2. On the remote control, press the SYSTEM MENU button.
  3. Press the down arrow button to select Setup .
  4. Press the ENTER button.
  5. Press the down arrow button repeatedly until Speakers is selected.
  6. Press the ENTER button.
  7. Press the ENTER button again to select Audio Output Mode .
  8. Press the down arrow button to select 5.1 Channel .
  9. Press the ENTER button.
  10. Press the down arrow button to select Speaker Setup button.
  11. Press the ENTER button.
  12. Press the ENTER button again to select Next Screen .
  13. Press the down arrow button to select Ls/Rs .
  14. Press the left arrow or right arrow button to select Yes .
  15. Press the ENTER button.
  16. Press the SYSTEM MENU button to exit.