Article ID : 00070755 / Last Modified : 08/15/2015

Error: Information of the computer where data is to be saved is not set to the device.

Applicable Products and Categories of This Article

This message will appear on the camera if it was not connected to the computer for the initial set up to activate the wireless function. It should be set up with PlayMemories Home™ software first to enable the wireless settings before starting a wireless transfer. Follow the steps below.

  1. Turn off the camera.
  2. Start the PlayMemories Home software on the computer.
  3. With the supplied USB cable, connect the camera to the USB port of the computer.
  4. Turn on the camera.

NOTE: The PlayMemories Home software will register the camera and detect the wireless function.