Article ID : 00018940 / Last Modified : 11/28/2017

The Camera Doesn't Turn On or Off After a Firmware Update

Applicable Products and Categories of This Article

The camera may become unresponsive or fail to turn on after the firmware is updated. This may be due to a low battery or an incomplete firmware installation. Follow these steps to address the issue:

  1. Make sure the battery is fully charged. If you have the optional AC power adapter, connect it to the camera and a working electrical outlet.

    Note: Batteries discharge faster when used in cold weather conditions.

  2. Check if the USB cable is working properly.
  3. Perform a manual reset on the camera.

  4. If the camera won't turn on after the manual reset, run the firmware again.
  5. If necessary, use a different computer.

If the issue still occurs, repair may be required. Go to Product Repair.