Cannot playback audio files from a mobile device.

IMPORTANT: This article applies only to specific products and/or operating systems. Check Applicable Products and Categories for details.

To troubleshoot the issue, check the following.

• Check if No device connected appears on the status screen of the Future Lab Program N app. If this message appears, perform the Initial Setup and reconnect the Neckband-style wearable device and your smartphone via Bluetooth® connection.

  Bluetooth connection setup

  Follow the steps below to setup the Bluetooth connection on the Neckband-style wearable device.

  NOTE: The images below were taken from a Sony Xperia® smartphone. The steps on how to enable the Bluetooth feature of the smartphone vary depending on the model number. Refer to the manual or contact the manufacturer of the smartphone for additional information.

  1. On the mobile device, tap the Settings category.

     

  2. Select Bluetooth.

     

  3. Confirm that FL-N01 shows as Connected.

     

     NOTES:

     • If it does not show Connected, tap it until a connection is made.
     • If it shows Connected (no media), tap it to disconnect, and tap to reconnect.
     • If the connection is not made even when tapped, turn the Bluetooth function of the smartphone off and then back on.
• The music source might be set to device mode. To change to a different mode, press the Custom button, until it is set to Streaming mode.

  NOTE: This setting can also be adjusted using the Future Lab Program N app or through voice commands.