Article ID : 00115441 / Last Modified : 08/22/2019Print

How to Initialize the Touchpad Remote Control

    IMPORTANT: This article applies only to specific products and/or operating systems. Check Applicable Products and Categories for details.

    1. Unplug the power cord of the TV.

      Note:  It is not possible to reset the remote while the TV is connected to AC power.

    2. Remove the battery cover of the Touchpad Remote Control.

    3. Take out the batteries and put them back in.

    4. Press and hold the VOLUME MINUS (-) button.

    5. While holding the VOLUME MINUS (-) button, press and hold the POWER button.

    6. While holding down the VOLUME MINUS (-) button and POWER button, press the TOUCHPAD AREA for 3 seconds.

      Note: The image below shows the buttons that have to be pressed in the steps above.


      Note: When initialization is successful, the red light at the back of the Touchpad Remote Control will blink twice and slowly.

      Remote Red Light

    7. Plug in the power cord of the TV.

    IMPORTANT: After initialization, it is necessary to pair the Touchpad Remote Control with the TV  before use.