Article ID : S1F1470 / Last Modified : 08/13/2019

Steering Wheel Control Compatibility

    General Notes

    • Car manufacturers can change the wiring specifications without notice. Be sure to locate the correct wires before beginning installation.
    • Sony recommends using a professional for installation.
    • Please refer to the operating instructions or contact the manufacturer of your car or car dealer for more information.
    • All connections shown in this chart are from the wire side, not the terminal side.
    • It is recommended that all car stereo installations be performed by a qualified, professional installer.
    • Be sure to connect each lead properly to avoid damage.
    • Cover any unused leads with electrical tape for safety.
    • Do not connect the cable if you are not using the steering wheel control feature.
    • This information is subject to change without notice.


    XAV-65 Supplied Cable

    XAV-65 supplied cable

    Car Wiring Configurations

    Manufacturer Connector Type Pin Assignment Notes
    Toyota 20P toyata 20 pin Input 1:1
    Input 2:2
    GND = G
     
    26P toyata 26 pin Input 1:1
    Input 2:2
    GND = G
     
    28P toyata 28 pin Input 1:1
    Input 2:2
    GND = G
     
    Honda 20P-A honda 20 pin configuration a Input 1:1
    Input 2: N/C
    GND = G
     
    20P-B honda 20 pin configuration b Input 1:1
    Input 2: N/C
    GND = G
     
    24P honda 24 pin Input 1:1
    Input 2: N/C
    GND = G
     
    Nissan 16P-A nissan 16 pin configuration a Input 1:1
    Input 2:2
    GND = G
     
    16P-B nissan 16 pin configuration b Input 1:1
    Input 2:2
    GND = G
     
    20P nissan 20 pin Input 1:1
    Input 2:2
    GND = G
     
    Mitsubishi 20P mitsubishi 20 pin Input 1:1
    Input 2: N/C
    GND = G
     
    Mazada 24P mazda 24 pin Input 1:1
    Input 2: N/C
    GND = G
     
    Subaru 8P Subaru 8 pin Input 1:1
    Input 2: N/C
    GND = G
     
    20P Subaru 20 pin Input 1:1
    Input 2: N/C
    GND = G
     
    Maruti Suzuki 20P Suzuki 20 pin Input 1:1
    Input 2: N/C
    GND = G