Sony SupportWireless Speakers

Article ID : 00348093 / Last Modified : 12/04/2024Print

How to reset or initialize the LinkBuds Open (WF-L910)

    Reset the LinkBuds Open

    1. Put the LinkBuds Open units into the charging case.
      Note: Leave the charging case lid open.
    2. Press and hold the reset button on the back of the charging case for approximately 20 seconds or longer, until the indicator flashes orange.
    3. Continue holding the reset button until the charging indicator flashes orange for about five seconds and then turns off to indicate that the reset process is complete.
      Note: Do not release your finger from the reset button on the charging case while the indicator is flashing orange. If you release your finger, the headphones will be initialized.
      The reset button is on the left side of the USB Type-C® port on the back of the charging case. The lamp is on the front of the charging case.

    Note: The pairing information and other settings are retained.

    Hint: Watch the video to find out how to reset.

    Initialize the LinkBuds Open to restore the factory settings

    IMPORTANT: The initialize operation resets all the device settings to the factory defaults and deletes all pairing information.

    1. Set the LinkBuds Open units into the charging case.
      Note: Leave the charging case lid open.
    2. Press and hold the initialize button on the back of the charging case for about 15 seconds or more.
      The indicator on the charging case repeatedly flashes blue twice in a row, and then the indicator flashes orange.

      Initialize button is on the left side of the USB Type-C port on the back of the charging case. The lamp is in the middle of the charging case.
    3. Release your finger within 5 seconds after the indicator on the charging case starts flashing orange.
      When the initializing is complete, the indicator on the charging case flashes green 4 times.

      Note: If the indicator on the charging case does not flash green 4 times after performing step 3, the headphones have not been initialized. Try again from step 2.

    Notes:

    • To pair the headphones with a Bluetooth device, delete the pairing information from the smartphone's connected devices list and then perform the pairing again to reconnect to the smartphone.
    • When the charging case's remaining battery charge is insufficient, the headphones will not start initializing. Charge the charging case.

    Hint: Watch the video to find out how to initialize.