Article ID : 00028932 / Last Modified : 08/16/2015

Error: NO SIGNAL is displayed on the LCD panel.

Applicable Products and Categories of This Article

Follow the steps below to troubleshoot this issue:

  1. Press the OFF button to turn off the LCD panel.
  2. Ensure the video source is properly connected to the clock radio.
    1. If using an antenna or direct cable, ensure it is connected to the VHF/UHF jack [FIG. 1] .
    2. If using a cable or satellite set-top box, ensure it is connected to the VHF/UHF jack [FIG. 1] or Audio/Video (A/V) input jacks [FIG. 1] .
    3. If using a VCR, ensure it is connected to the VHF/UHF jack [FIG. 1] or A/V input jacks [FIG. 1] .
    4. If using a DVD or Laser Disc player, ensure it is connected to the A/V input jacks [FIG. 1]
  3. Ensure the video source device is turned on.
  4. NOTE: This step does not apply when using an antenna or direct cable.

  5. Press the TV ON button to turn on the LCD panel.
  6. Tune the LCD panel to appropriate channel or video input.
    1. If using antenna or direct cable, simply tune the LCD panel to the desired channel for viewing.
    2. If the video source device is connected to the VHF/UHF jack only, tune the LCD panel to channel 3 or 4.
    3. If the video source device is connected to the A/V input jacks, press the TV/VIDEO button to tune the LCD panel to the VIDEO mode.
  7. If the NO SIGNAL error is still displayed, try the following:
    1. If using an antenna, adjust its position.
    2. Replace the cable between the video source device and clock radio.
    3. Connect a different video source device to the clock radio to see if the picture from other devices can be displayed.

NOTE: If the issue is still unresolved after completing the troubleshooting steps, service may be required .