IMPORTANT: This article applies only to specific products and/or operating systems. Check the Applicable Products and Categories section of this article before starting these steps.
- Unplug the power cord of the TV.
Note: It is not possible to reset the remote while the TV is connected to AC power.
Remove the battery cover of the Touchpad Remote Control.
Take out the batteries and put them back in.
Press and hold the VOLUME MINUS (-) button.
While holding the VOLUME MINUS (-) button, press and hold the POWER button.
- While holding down the VOLUME MINUS (-) button and POWER button, press the TOUCHPAD AREA for 3 seconds.
Note: The image below shows the buttons that have to be pressed in the steps above.Note: When initialization is successful, the red light at the back of the Touchpad Remote Control will blink twice and slowly.
- Plug in the power cord of the TV.