Article ID : 00142202 / Last Modified : 03/14/2017

The Blu-ray Disc Player does not automatically connect to a Bluetooth device.

Applicable Products and Categories of This Article

IMPORTANT: This article applies only to specific products and/or operating systems. Check the Applicable Products and Categories section of this article before starting these steps.

If the Blu-ray Disc® player does not automatically connect to a Bluetooth® device, check the following:

IMPORTANT: To avoid connection interference, make sure all Bluetooth devices placed near the Blu-ray Disc player are turned off.

  • Verify that the Bluetooth function of the Blu-ray Disc Player is enabled.
    1. On the supplied IR remote control, press the HOME button.
    2. Select Setup.
    3. Select Bluetooth Settings.
    4. Select Bluetooth Mode.
  • Verify that the Bluetooth device is registered on the Blu-ray Disc Player.
    1. On the supplied IR remote control, press the HOME button.
    2. Select Setup.
    3. Select Bluetooth Settings.
    4. Check the contents of the Device List.

      NOTE: If a Bluetooth device is paired to the Blu-ray Disc player, delete the pairing information from the Device List. Make sure the Bluetooth device is disconnected prior to the connection registration. Once the device connection is erased, you can then start a new Bluetooth connection registration.