IMPORTANT: This article applies only to specific products and/or operating systems. Check the Applicable Products and Categories section of this article before starting these steps.
Neural:X isn't enabled for DTS sources with sampling frequencies between 96 - 192 kHz. As a result, the sound isn't output from the soundbar, Dolby Atmos®, or other speakers.
Follow these steps to enable Neural:X on the connected device. Check your device manual for model-specific information.
- Make sure to use an HDMI® cable to connect the device to your soundbar or Multi Channel A/V receiver.
- Set the audio channel settings to LPCM or Dolby other than DTS.
- Set the audio output settings to LPCM.